US

# ARSTSY CRAFTS

US
By SG
Fri, 09, 19

Measure one face of the Rubik’s cube. Once measured, draw out a square on the blank paper using the measurements....

# Lenticular photo card

Material

• Two photos of the same size
• One scrapbook/construction paper
• Glue
• Scissors
• Ruler

Method

1- First, measure the length and width of both images. Then mark both the width of 1 image and the total length of both images onto the scrapbook paper. Then cut along the lines using scissors.

2- Next, mark a point at every 1cm of the back of a photo. Then draw a line down as shown below.

3- Number them as shown below. Cut along the lines and do the same for the second photo. Avoid messing these two up as it could get very confusing.

4- Let’s get back to the cut-out scrapbook paper. Mark a point every 1 cm just like we previously did for the two photos.

5- Fold the first one back and the second part forward. Do the same for the remaining paper.

6- Take the image labeled 1 of the first image and paste it on the first part of the folded scrapbook paper. Do the same for the second image.

7- Repeat with the other number photos. Cut out any excess of the scrapbook paper and discard any leftover or unused part of the image.

8- Next, we are going to make a backing for it. Grab the scrapbook paper and place the lenticular photo on top. Measure 0.5cm outwards from all sides of the lenticular photo and mark it. After that, match the marks and glue the lenticular photo on it.

# Rubik’s photo cube

Material

• 1 Rubik’s Cube (standard one)
• 6 Photos
• Scissors
• Glue/tape
• Ruler
• Pencil
• A paper

Method

1- Measure one face of the Rubik’s cube. Once measured, draw out a square on the blank paper using the measurements. Cut along the lines.

2- Use this blank cut-out as a guide when cutting the photos.

3- Once you cut out the main subject of each photos. Measure the small squares of the cube.

4- Then draw lines on the cut out photo based on the measurement. Label each box to ensure that the order would not be mix up.

5- Once done, cut along the lines. Then, paste it on one side of the cube using either glue or tape. Cut any excess if it protrudes out of the small squares. Cut the edges to be more rounded so that the edges will not be sharp.

6- Repeat again until you have covered all sides of the cube. There are 9 small squares on each face of the Rubik’s photo cube, with 6 faces it’s a total of 54 small squares! Take your time.

Compiled by SG

By US Desk

By US Desk

By US Desk